Friday 9 November 2012

Neuron / Difference Rectifier PCBs

 AU$8 each (+ shipping AU$5 per order) 

From thread on muffwiggler:

I keep getting asked about these so have sent off a design for a pcb containing 1 of each of these circuits. 

The Difference Rectifier has 4 inputs (two + & two -) and two outputs. The Neuron has two inputs and one output. There is a pad labelled 'ext' where extra inputs can be added if desired (use a 100k resistor attached to the jack). 


All inputs for both circuits can be wired to attenuating pots if required. The two pots on the PCB are the critical Offset and Invert controls for the Neuron. The Offset is slightly modded from the previous Double Neuron PCB as it now ranges between +V and -V and its effect is halved by the 200k resistor to give greater useful range.
Schematics and demos - Difference Rectifier and Neuron

Build manual pdf 

The PCB is small so will suit Euro builders. Approx 1.5 by 2 inches.
The 2 board mounted pots (both 100k) are 1 inch apart, the idea is to mount the PCB to the panel with threaded pots. There are 2 mounting holes otherwise if you want to attach the board some other way.







 

2 comments:

  1. Do you have a photograph of a built up module connected to the pots and jacks? actually ill ask on muff's

    ReplyDelete
  2. sorry no
    I use the double neurons on my panels which are a very different layout and my diff-rectifiers are on a noise PCB. Don't worry many people will be building these so I am sure you will get to see many pictures before too long.

    ReplyDelete

Note: only a member of this blog may post a comment.